ASTM D8257 D8257M-22 陡坡屋顶用机械连接聚合屋顶垫层的标准规范

ASTM D8257 D8257M-22 陡坡屋顶用机械连接聚合屋顶垫层的标准规范

基本信息

标准号:ASTM D8257/D8257M-22
发布单位或类别:美国-美国材料与试验协会(US-ASTM)
发布日期:2022-02-01
实施日期
废止日期
CCS分类
ICS分类

91.060.20   建筑构件 – 屋顶

91.100.50   建筑材料 – 粘合料、密封材料

适用范围/摘要

1.1 本规范涉及陡坡屋顶中使用的机械连接聚合物屋顶垫层。 1.2 本规范的目的是提供一种成品,该成品将在安装主要屋顶覆盖之前和之后用作陡坡屋顶上的排水垫层。 1.3 以国际单位制或英寸-磅单位表示的数值应单独视为标准值。每个系统中规定的值可能不是精确的等效值;因此,每个系统应相互独立使用。将两个系统的值合并可能会导致不符合标准。 1.4 本标准并非旨在解决与其使用相关的所有安全问题(如有)。本标准的用户有责任在使用前制定适当的安全、健康和环境实践,并确定监管限制的适用性。 1.5 本国际标准是根据世界贸易组织技术性贸易壁垒(TBT)委员会发布的《关于制定国际标准、指南和建议的原则的决定》中确立的国际公认标准化原则制定的。

1.1 This specification addresses mechanically attached polymeric roof underlayment used in steep slope roofing. 1.2 The objective of this specification is to provide a finished product that will be used as a water-shedding underlayment layer on steep sloped roofs prior to and after installation of the primary roof covering. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

研制信息

起草单位

起 草 人

归口单位
D08.02

© 版权声明
THE END
喜欢就支持一下吧
点赞5赞赏 分享